![]() This setting requires a code only if there are faulted zones when arming. Auto Bypass on Arm - (Honeywell only) Set to true to automatically bypass all open zones by sending code + 6# before arming.See Arming Key Sequences section below for more information. For both systems, whenever this option is set to true, a code will be required for night arming regardless of the Code Required for Arming setting. For DSC systems, set to true to enable No-Entry mode instead of Stay mode for night arming. ![]() Alternative Night Mode - For Honeywell systems, set to true to enable Night-Stay mode instead of Instant mode for night arming.There are currently 3 arming settings for AlarmDecoder (shown below). Once AlarmDecoder has been set up according to the instructions above, the arming settings and zones can be configured by selecting Options on the AlarmDecoder card on the Settings -> Devices & Services page. baud rate - the baud rate of the AlarmDecoder device (i.e.path - the path to the AlarmDecoder device (i.e.port - the port that AlarmDecoder is accessible on (i.e.host - the hostname or IP address of the machine connected to the AlarmDecoder device.Depending on your selection, you will be asked for the following connection information: You will be prompted to select a protocol (i.e. If the above My button doesn’t work, you can also perform the following stepsįollow the instructions on screen to complete the setup. To add the AlarmDecoder integration to your Home Assistant instance, use this My button: ![]() Any event sent by the AlarmDecoder device will be immediately reflected within Home Assistant.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |